lfc84
17-07-22, 15:02
I've got vix image running on a solo2 and using a Stab hh motor.
If I select anything more westerly of 5W the dish will move from 19e (for example) and then reach 5w where it stops and then moves back towards the east.
I was using openvix 6.2.002 so I flashed a new image.
It worked perfectly for an hour. I could get everything I needed over to 30w and back east.
I took an image backup.
I was doing some channel zapping, perhaps impatiently and the problem had reoccurred. I notice that if I move to a sat and the channel remains encrypted the dish will automatically move to the previous channel on another sat.
I've set my location co-ords in the vix image and currently can go from 5w to various sats in the east.
I've turned off limits in the image.
I've installed a new image and setup from scratch. Still same problems.
I also restored my backup image and have the same problems.
My location means that 5w is due south, in case that matters
If I select anything more westerly of 5W the dish will move from 19e (for example) and then reach 5w where it stops and then moves back towards the east.
I was using openvix 6.2.002 so I flashed a new image.
It worked perfectly for an hour. I could get everything I needed over to 30w and back east.
I took an image backup.
I was doing some channel zapping, perhaps impatiently and the problem had reoccurred. I notice that if I move to a sat and the channel remains encrypted the dish will automatically move to the previous channel on another sat.
I've set my location co-ords in the vix image and currently can go from 5w to various sats in the east.
I've turned off limits in the image.
I've installed a new image and setup from scratch. Still same problems.
I also restored my backup image and have the same problems.
My location means that 5w is due south, in case that matters