HDD no longer recognised

[cojones]

Hi, I have a 3 month old HD61 4K with a pre-installed Toshiba 1TB HDD. It's worked flawlessly (openatv 6.4, 7.0 and OpenVix 6) until a few days ago. Now the HDD cannot be seen - it cannot be mounted, I get 'mount failed' and any operation on the HDD fails, even initialisation - which I see the attached error for. can anyone suggest how to resolve this issue? I've got a number of recordings on it but am resigned to losing them. I just want a HDD that works.

media/usb the usb stick that I'm using for backups, epg etc I've tried renaming the HDD to media/HDD but it reverts back

I've even tried mounting via telnet but get the following...


mount /dev/sda1 /media/hdd
NTFS signature is missing.
Failed to mount '/dev/sda1': Invalid argument
The device '/dev/sda1' doesn't seem to have a valid NTFS.
Maybe the wrong device is used? Or the whole disk instead of a
partition (e.g. /dev/sda, not /dev/sda1)? Or the other way around?
mount: mounting /dev/sda1 on /media/hdd failed: No such file or directory

Also...


~# df -h
Filesystem Size Used Available Use% Mounted on
/dev/mmcblk0p23 5.2G 1.5G 3.4G 31% /
devtmpfs 929.3M 40.0K 929.3M 0% /dev
tmpfs 64.0K 0 64.0K 0% /media
/dev/mmcblk0p4 2.0M 20.0K 2.0M 1% /boot
tmpfs 929.6M 1.6M 928.0M 0% /var/volatile
/dev/sdb1 57.3G 1.2G 56.1G 2% /media/usb

Can anyone help please?

6381663817

[adm]

If seen my HDD disappear on a couple of occasions over the past few years. My cure has been a complete cold boot which has restored HDD detection. Put the box into deep standby and then switch off at the mains for a couple of minutes before restoring the mains. The switch off period just allows any internal voltages inside the box to fully discharge.

[cojones]

Hi, thanks, yes I tried that and it didn't resolve it.

[cojones]

It appears that it was corrupted. I connected it to my pc and formatted it using HDDguru and initialised it back in the HD61 and it seems to work again. For how long I don't know. I've lost all my recordings but at least it's working.

I've got no idea what corrupted it as there was nothing obvious so i can't take any steps to prevent it happening again.

[adm]

I've got no idea what corrupted it as there was nothing obvious so i can't take any steps to prevent it happening again.

Power cut whilst still operating?
Switching off at the mains before putting the box into deep standby (or waiting for the 30ish seconds before the box finishes going into deep standby)?

[cojones]

Possibly, but I'm so aware of the risk of cutting power having had a career in IT that I'd be very surprised it's something I've done. I can't remember a recent power cut either. Strange but I've got it working now, so if it happens again I'll know what to do.