looking for advice on lnb adaptor type to get

[urie]

looking for advice on lnb adaptor type to get for https://www.world-of-satellite.co.uk/satellite-and-terrestrial/universal-and-unicable-lnb/gt-sat-gt-s2dcss24-unicable-lnb-2-legacy this is current lnb holder https://www.amazon.co.uk/gp/product/9792365222/ref=ppx_od_dt_b_asin_title_s00?ie=UTF8&psc=1

also here is picture of current lnb

61751
61755

At the moment I have sky box in living room and zgemma h9 combo in bedroom both running off seperate feeds from sky quad lnb.

I am going to purchase zgemma h7s with GT-S2DCSS24 and GT-Sat GT-SP21 2 Way Satellite Splitter 5-2400MHz DC Pass Suitable for Unicable. feed the h7s from unicable lnb to splitter and sky box from lecacy connection on unicable lnb.

I also have WOS 97cm motorsced dish kit with technomate gold single lnb I purchased last march still to get that put up :) but will eventually be also including that in the system.

will i need to eventually purchase a GT-Sat GTPI1 Unicable / Universal LNB Power Inserter for the motorised dish ?

[urie]

I have made post in https://www.world-of-satellite.com/showthread.php?54875-Unicable-2-LNB-for-Sky-mini-dish-ok&p=511817&viewfull=1#post511817 think it should have been in this section.

[abu baniaz]

That is a Mk3 sky dish. You will have to hunt around for the holder/adapter for it. It slides inside the arm. Mk4 dish ones clip over the arm. Anther option is to use a non-sky lnb holder, drill hole in dish arm and fix holder with nut and bolt.

[urie]

I have found this typehttps://www.ebay.co.uk/itm/352584179793? I could probably put slide it over top of arm and drill through. think I have changed my mind wth reguards to the h7s think I will go all out a get the https://www.world-of-satellite.co.uk/satellite-and-terrestrial/digital-receivers/linux-enigma-2-receivers/gigablue_uhd_quad_4k just need to wait untill they are available is it possible to multiboot this stb simmilar the zgemma h9 combo.

[bmitie]

You can multiboot the H7S as well. That adaptor looks ok but it does say out of stock on that link. Why ywould you need the GT-Sat GTPI1 Unicable / Universal LNB Power Inserter?

[urie]

You can multiboot the H7S as well. That adaptor looks ok but it does say out of stock on that link. Why ywould you need the GT-Sat GTPI1 Unicable / Universal LNB Power Inserter?

I was thinking about later on when I setup the motorised dish, is the power inserter not needed with unicable. the lnb adapter is not out of stock :)
Yes I know the h7s has multiboot build it but I think I have may go for the Gigablue UHD Quad 4K does that have multiboot i.e. different partitions like the zgemmas or do you need to install it on micro sd card if so does that not slow it down ?

[abu baniaz]

The LNB has a chip, it needs power. You can power it using the receiver or using a power inserter. The power inserter is not needed, it is optional. The benefit of using an inserter is that the LNB is always powered on, so you don't have to wait for it to power on. (There was an issue with the Gigablues some time ago where the LNB power was being switched off causing tuning problems, this may where the conception of need came from.)

The multi-boot is on internal flash memory.

Are you planning to put the unicable LNB on your motorised dish?

[urie]

I was just going to put the unicable lnb on to the fixed sky dish. But unicable lnb will be later on cannot afford the Gigablue and unicable lnb at the same time :) or may just get the unicable lnb and forget internal hard drive stick usb thumbdrive in it for the moment.

[JonMMM]

If you do change from standard to Unicable LNB completely reflash and start from scratch, it will make life easier