View Full Version : [Zgemma H7] Help needed with WiFi dongle
Hi,
Only just got my Zgemma H7. Haven't been able to get my WiFi dongle to talk to the box.
The usb dongle is a TP Link T2U nano. I've tried the various drives available through the plugin downloads but none work.
Plenty of dongles on the market but its the chipset it has and if its supported on plugins feed.
That one looks tiny and the proper ones have an antenna.
Thinking your might not be a supported one?
Should have asked if you rebooted box after drivers were downloaded and is it seen?
Try the network-usb-mt7610u driver and reboot the receiver. If that doesn't work you are probably out of luck.
Just to be clear I would do a hard re-boot ie power off at rear.
Just to be clear I would do a hard re-boot ie power off at rear.
I would hope you are shutting down the receiver first before powering off
Looks like it has a rtl8812au chipset?
Try:
enigma2-plugin-drivers-network-usb-rtl8812au
This is what I found
deviwiki.com/wiki/TP-LINK_Archer_T2U but of course TP Link usually has several different revisions of each product and its difficult to ascertain what is inside.
The OP could try plugging it into a PC/laptop and see what sort of drivers are loaded.
There is a T2U and a T2U Nano. Probably different chipsets.
But yes, plugging it in somewhere else to see what it claims to be might be useful.
The box itself will already be doing this, but if you can't connect to it as you have no network that's not so helpful.
Perhaps a menu option to display dmesg output would be useful....
Hi all
Thanks for the replies. I put the dongle into my laptop. All I could figure out was what's in the screen shot below.
I thought I saw somehere as follows "rtl8128.ce" think it was in the windows/system32/drivers folder. https://uploads.tapatalk-cdn.com/20210305/dac76b30f07828aaf54dcd166c449924.jpg
Sent from my SM-A920F using Tapatalk
Have you actually tried the enigma2 enigma2-plugin-drivers-network-usb-rtl8812au package?
The TP-Link instructions for building the Linux driver at:
https://www.tp-link.com/uk/support/download/archer-t2u/#Driver
set
CONFIG_RTL8821A = y
and it's a USB version, hence the u suffix.
Have you actually tried the enigma2 enigma2-plugin-drivers-network-usb-rtl8812au package?
The TP-Link instructions for building the Linux driver at:
https://www.tp-link.com/uk/support/download/archer-t2u/#Driver
set
CONFIG_RTL8821A = y
and it's a USB version, hence the u suffix.Tried that package,no joy.
Will try build the driver later
Thanks
Sent from my SM-A920F using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.