Network mount differs in scan

[cactikid]

I lost my network mounts again either by reboot or router getting powered off and had to delete all mounts.

Setup fresh mounts again on h7 but notice the et 10000 does not work.

Fresh network scan and see et 10000 differs on both boxes:confused::confused:

Only thing i can think of other boxes got powered off and the et 10000 was not.

Why does it get a wrong ip in a scan :confused::confused:

213 is box ip of et 10000
214 is box ip on H7S scan which is wrong:smash::smash:

[cactikid]

Rechecking it today et 10000 now shows ip as 214 so it must have changed itself and files and mount now seen.

If trying to mount it by ip it only shows as a NFS and wondered if that can be changed to a CFS if i needed to ??

Just asking.

[abu baniaz]

Q1.Have you fixed the IP addresses on your router?
Yes/No. answer please.

Q2.
If above answer is No, are you using fixed IP addresses or DHCP on box?
Multiple choice
N/A (because assigned IP addresses on router)
DHCP
Fixed IP address

Please don't state anything else in your response. Make a separate post if you have something else to say.

[cactikid]

Q1.Have you fixed the IP addresses on your router?
Yes/No. answer please.

Q2.
If above answer is No, are you using fixed IP addresses or DHCP on box?
Multiple choice
N/A (because assigned IP addresses on router)
DHCP
Fixed IP address

Please don't state anything else in your response. Make a separate post if you have something else to say.

Q1 No not checked router

Q2 DHCP used

[abu baniaz]

Your boxes should have fixed IP addresses unless you want to connect to them using their host names. How do you want to assign fixed IP addresses? Answer from two choices below please.

On Box
On Router

[cactikid]

When setting up from scratch and it assigns me the box ip

On Box.

[abu baniaz]

Please disable dhcp on box and assign fixed IP addresses. Do this on all boxes.

If you don't know how to do it, just ask.