View Full Version : VU Solo will not move dish
I am very new and have just received a Solo. It will not move from 19e also i am unable to use the tuner. I think that it must be ME
The motor is not faulty but the Enigma 2 keeps crashing to a green screen
I replaced the old image with VIX ver 2 today although different skin it works the same and no dish movement I have tried some extra plugins to have better dish control to no effect.
This forum helped me to choose the Solo - I now think the DUO may have been better
bassethound
10-02-11, 21:35
You need to go to menu/setup/service search/tuner configure/ select tuner A
then change settings in here to you dish type
Check your tuner configuration, should be something like the screenshot below, using your long and latt settings
http://www.world-of-satellite.com/attachment.php?attachmentid=382&d=1274390993
Then upload a set of Enigma 2 settings, Catseyes pack are a good set to start with http://www.world-of-satellite.com/showthread.php?42-Catseye-Enigma2-Settings-file-75-East-to-58-West/page3 Guide to upload settings here http://www.world-of-satellite.com/showthread.php?623-How-to-send-save-Enigma-Settings-to-the-VUDuo-using-DBEdit
Thanks to bassethound and Sicilian for you pointers I have to go sideways on the menus as well as up/down - found lots of things most interesting but geeky at this time. The screen shows a rotating aerial but dish stays still.
I still have to move Dish manually as I get a green error screen often - unfortunatly it goes before I can read it.
My motor is TM-2300 - I am not config tuner to suit - hope to get more time
Vu has very good picture.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.