DD33
22-03-19, 08:52
Morning folks, will try to explain this as best as I can. I recently got a Technomate Nano 3T Combo and installed Vix. I just have one feed into it (satellite cable). Everything works fine for a few hours but then the onscreen menus disappear. So if I hit the menu button on the remote nothing happens onscreen but it changes the text on the front panel of the box to menu. If I am on channel 4 for instance and change the channel to channel 5 the text on the front of the box changes to channel 5 but the TV is still showing channel 4!
Now this is where it gets really confusing! I have the 3 rca cables coming out of the back of the box going to a triax tri-link which feeds to tvs throughout the house. I went to the room next door which receives the feed from the triax (also have a digital eye in that room) and tried hitting the menu buttons, going through channels etc and everything works, displays & changes fine! Went back into the main TV which is fed through the hdmi and it was still on the same channel as before.
The only way I can get the menus, channel changes etc to work again on the main TV is to turn the box on and off again.
Any help or advice would be much appreciated.
Thanks for your time in reading this
DD
Now this is where it gets really confusing! I have the 3 rca cables coming out of the back of the box going to a triax tri-link which feeds to tvs throughout the house. I went to the room next door which receives the feed from the triax (also have a digital eye in that room) and tried hitting the menu buttons, going through channels etc and everything works, displays & changes fine! Went back into the main TV which is fed through the hdmi and it was still on the same channel as before.
The only way I can get the menus, channel changes etc to work again on the main TV is to turn the box on and off again.
Any help or advice would be much appreciated.
Thanks for your time in reading this
DD