juicyjusuf
28-08-18, 22:35
Hi,
I currently using OpenVix 5.0 on my VUSolo2 on cable. I have been using ccam fine and decided to use mgcamd.
Not been having much luck.
Tried again today and same issue, but i thought i would do another restart after making mgcamd to start up but this time the box starts but comes up with the attached error and wont go any further. It is currently stuck in a loop.
Left it switched off etc but to no avail.
Error:
"Your receiver encountered a software problem and needs to be restarted, Please send log file"
This is in a constant loop where it tries to start and then comes up with the above.
Attached screenshot of error & log files.
Any advice would be much recommended. Thank you
I currently using OpenVix 5.0 on my VUSolo2 on cable. I have been using ccam fine and decided to use mgcamd.
Not been having much luck.
Tried again today and same issue, but i thought i would do another restart after making mgcamd to start up but this time the box starts but comes up with the attached error and wont go any further. It is currently stuck in a loop.
Left it switched off etc but to no avail.
Error:
"Your receiver encountered a software problem and needs to be restarted, Please send log file"
This is in a constant loop where it tries to start and then comes up with the above.
Attached screenshot of error & log files.
Any advice would be much recommended. Thank you