View Full Version : Stab motor not driving to correct satellite degrees
trekkertos
10-11-17, 17:40
Sorry
I am a newbie
I have a vu + dual receiver with a stab motor rotor sat hh100.
The vu+ is preconfigured for me.
I have set the dish up but when the receiver asks the motor to go to say astra 28.2 the position of the motor goes to about 34.
Not aligning up with anything.
Can anyone please help
Thanks
wrong usuals settings ? OR disc not on the right position installed.
use https://www.latlong.net/ and go to youre position.Then adjust until good signal.
Sorry
I am a newbie
I have a vu + dual receiver with a stab motor rotor sat hh100.
The vu+ is preconfigured for me.
I have set the dish up but when the receiver asks the motor to go to say astra 28.2 the position of the motor goes to about 34.
Not aligning up with anything.
Can anyone please help
Thanks
Well loosen the nuts on the dish and line it up with what the receiver position wants, or give the motor fixed positions.
Or you can start again and set up the motor and send it to 0.8 degree South and and loosen the nuts and manually adjust the dish at that position.
You set up the motor first and adjust the dish to suit.
he needs to adjust to the closer sat on his position.Not always 0.8 degrees.In my case it is 5 E . He is 6 degrees off so probably they configured the wrong latitude and longitude.
trekkertos
10-11-17, 20:06
Thanks for info, will give it another go tomorrow.
Sorry
I am a newbie
I have a vu + dual receiver with a stab motor rotor sat hh100.
The vu+ is preconfigured for me.
I have set the dish up but when the receiver asks the motor to go to say astra 28.2 the position of the motor goes to about 34.
Not aligning up with anything.
Can anyone please help
Thanks
Hi mate ,first you need to setup you tuner configuration ,
configuration mode simple
mode positioner
longtitude
longtitude
all information about (your location )west and north,
the same latitude you add on tuner config the same you have to put on motor,if you try before manually with the satab motor ,make sure to set the motor to 0 degrees before you start to install ,also upload the providers what you want with the dreamset ,and try your best inst easy but have look few time this video here and try your best ,for any question we are here ..
https://www.youtube.com/watch?v=-k_yhxmGlEA
regards Nick
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.