Latest VIX 5, AGC shows extremely low

[sebus]

Swapped my old Gigablue HD800SE old Vix 3.2.037 for Mut@nt HD1500 with latest Vix 5.0.017
Dish/motor untouched.

On GB I was getting SNR/AGC on some channels on 13E that I watch most ~ 85+/75+

Now Mut@nt shows 72/47 or on some even 80/2

BER =0

None of them breaks, so I wonder if the values are just wrong or could be the LNB going?

There should not be these values discrepancy on channels from same provider on same sat, right?

sebus

[Sicilian]

It's drivers, use as a guide only. I've never seen any e2 box give an accurate reading.


Sent from my iPhone using Tapatalk

[ronand]

There will be variations between transponders. The strengths will vary, the beams will vary.

[sebus]

Thanks, as long as the channel does not break, I will ignore the numbers.
I can expect variations, but 75 to 2 is way too much to just attribute it to this

[twol]

AGC is totally meaningless and should be ignored completely.
As commented, SNR depends on the receiver drivers and a couple of other parameters, whichmeans it can really be only used for tuning and not comparing different receivers