PDA

View Full Version : [VU+ Solo2] Only Seeing sat 13e?


dpullen87
09-06-17, 18:55
Hi all.

for some reason i'm only seeing one sat in my tuner config, i can't select 28.2 it only show 13e?

any ideas?

Cheers
Andy_Hazza
09-06-17, 19:00
You will have setup your Tuners wrong. Go back and look at the tuner setup. Menu > Setup > Service Searching > Tuner Configuration.


Sent from my iPhone using Tapatalk
Ford1
09-06-17, 19:22
If you have used echannalizer to import iptv bouquets, make sure you have restarted your device, I have had issues when it has knocked off the 28.2 satellite
dpullen87
09-06-17, 19:45
Not using IPTV, the sats weren't there when trying to setup timers.

Flashes latest version whixh put them back but lost all my sat settings as have motorised. Retrieved from old settings file and reapplied using init 4 then 6.

Seems ok now.

Cheers
dpullen87
10-06-17, 19:43
It's happened again and seems to be after a reboot, restored a settings backup but still not there.

I have a motorised setup on tuner A and I can only select 13e in tuner config and the same for sky dish on tuner B.

Any ideas how to fix without flashing fresh image and copying nims out of old settings file?
dpullen87
10-06-17, 19:59
Couch flash and restore of settings resolved, strange why this keeps happening.
s2tephen
10-06-17, 21:30
I do not know if this is the same issue but
Every now and then when I go into Autobouquetmaker I can only find one satellite listed and that is 13 degrees.
On a reboot it then shows all of the sats I have set up ie 28 - 23 - 19 - 13.
So something strange is going on.
This has been happing for a while now.
Do not think its the box I have VU Ultimo 4k and also used to happen with the Duo 2 before.
Maybe a problem with Autobouquetmaker.
gilvey
11-06-17, 06:59
Are you using vhannibal plugin? If so make sure you set it up as motor then the sats 70e-45w otherwise it will revert to 13 when it auto updates. I had this issue myself and found that was the problem. Hope that helps
s2tephen
11-06-17, 09:35
Hi
No I am not using that plugin and the 4 sats are accessed via 4 seperate LNB's via switch no motor.


Are you using vhannibal plugin? If so make sure you set it up as motor then the sats 70e-45w otherwise it will revert to 13 when it auto updates. I had this issue myself and found that was the problem. Hope that helps
dpullen87
11-06-17, 09:43
I'm using vhannibals and have been for some time and it is set to 70e-45w, very strange.