View Full Version : How to view Direct Feeds
I was looking at the direct feeds on satelliweb.com, but can't work out how to view them.
I enter the details in manual scan, which all seems straightforward enough, but once the scan is finished where do I go to view the channel?
Cheers :)
Andy_Hazza
01-04-17, 16:47
Last Scanned Bouquet. It will be the last folder.
Sent from my iPhone using Tapatalk
Thank you, I must be doing something wrong with the scanning then as there's nothing showing in last scanned :confused: I'll keep playing for a while
Hi, I've been fiddling with this for the last few days and am no further on. Is there a handy guide somewhere? I'm not even sure I'm doing the scanning bit right...:rolleyes:
Andy_Hazza
05-04-17, 18:25
So you are doing Menu > Setup > Service Searching > Automatic Scan & Press Ok?
Sent from my iPhone using Tapatalk
DaMacFunkin
05-04-17, 18:53
I thought direct feeds where 4:2:2, the solo2 can't handle this chroma space.
So you are doing Menu > Setup > Service Searching > Automatic Scan & Press Ok?
Sent from my iPhone using Tapatalk
Hi, no Menu > Setup > Service Searching > Manual Scan and then entering the values from satelliweb, and then Scan. I get 4 horizontal blue lines under and the option to Cancel or OK
That means nothing was found. Either the transponder details are wrong or the feed is finished (or maybe you cant receive it in your location). Feeds on 10e may need a large dish. Also some are in 4:2:2 which wont display directly on your stb. And many are encrypted too. With DVB-S2 feeds the scanning parameters must be exact or nothing will be found.
So you are doing Menu > Setup > Service Searching > Automatic Scan & Press Ok?
Sent from my iPhone using Tapatalk
For feedhunting???
Hi, no Menu > Setup > Service Searching > Manual Scan and then entering the values from satelliweb, and then Scan.If you have transponder params you should use sat finder. Enter the details. See if the transponder is still active. If so press ok to scan.
For feedhunting???He is not hunting. He already has the parameters from the internet. If he were hunting he would need to use blind scan.
True. But an automatic scan is no use if the TP is not in the xml.
I've never use Auto for any sort of scan.
If you have transponder params you should use sat finder. Enter the details. See if the transponder is still active. If so press ok to scan.
Fantastic, thank you! :thumbsup:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.