View Full Version : Oscam - recordings and epg problems
Got alot of problems with oscam, changing channels makes it switch off automatically
Anyone else got this problem ?
Is there a solution ?
I also got alot of problems with recordings : slow picture when starting the recordings, alot of faults in the picture also.
Problems with epg : got 2 HDD, 1 built in and an external, epg is being saved to external and often when the box reboots or GUI restart, the epg is gone. Tried with saving epg to internal HDD but same problems.
I assume you are on openatv for that box. i had same issue a week back when I was setting up mine, but sorted it. setup your softcam, don't use emu one. once done, restart box. and go to oscam webif, see f things working from there, if not, restart from webif
bassethound
26-02-17, 11:30
I would try Ncam 1.1 its been rock-solid for me on the sf4008
see post 69 http://www.world-of-satellite.com/showthread.php?54754-New-Uno-4K/page5
What box mode have got set on the config file?
Sent from my iPhone using Tapatalk
not sure what you mean by box mode?
I assume you are on openatv for that box. i had same issue a week back when I was setting up mine, but sorted it. setup your softcam, don't use emu one. once done, restart box. and go to oscam webif, see f things working from there, if not, restart from webif
can't get to oscam webif, access denied it says
not sure what you mean by box mode?
Can you post the contents of your config file
Sent from my iPhone using Tapatalk
look on this forum and google, theres tones knocking around. http://www.world-of-satellite.com/showthread.php?54726-Oscam-for-VU-Uno-4k/page2&highlight=oscam+config+files
or try ncam. works a treat for me
also my recording are slow by a couple of seconds but then is fine. use internall hdd for epg
how does ncam work ? EPG on internal HDD gave me the same problem.
my oscam.conf :
[global]
[cccam]
port = 12000
reshare = 0
version = 2.3.0
[dvbapi]
enabled = 1
au = 1
boxtype = dreambox
user = dvbapiau
[webif]
httpport = 16002
httpuser =
httppwd =
httprefresh = 10
httpallowed = 127.0.0.1,192.168.0.100-192.168.0.200
Box type I was referring to is correct. I have protocol newcamd rather than cccam though
Sent from my iPad using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.