Motorised setup on Vu+ Receivers

[hsbajwa316]

Evening all,
I have a motorised setup in my main room (vu+ Solo2) which works fine using positioner (non-usals).
I am using a twin inverto black and have my 2nd connection from the motor into another room into 2nd receiver (Vu+ zero).

However with the 2nd connection I am unable to move the dish and it seems stuck on 19.2e. I have copied all the settings from the Solo2 but wondering if there is something else I should be doing.

Purpose of this setup is just to be able to watch the motorised channels in different rooms at different times

:confused:

[abu baniaz]

From one receiver, the wire goes to the motor (then LNB). You can move the motor.
From the other receiver, wire does not go to the motor. You cannot move the motor with that wire.

You would be better off using Remote channel stream converter plugin or fallback tuner. fallback tuner does not guarantee access to a tuner.

[hsbajwa316]

Ok good to know - thank you abu