View Full Version : All channels gone 🙁
Hi,can anyone help,I have an Vu plus 4k and up until a few days ago it's worked flawless,now I cannot watch any channels no matter what satellite I'm on and all I get is this message "No data on transponder timeout reading Pat"
Iv tried re tuning satellites iv done a factory reset but can't scan anything now
Anyone know what's up?
Thanks
Andy_Hazza
05-01-17, 14:21
Have a look at your cabling & f-connectors to the rear of your receiver if nothing else has changed. What setup do you have?
Sent from my iPhone using Tapatalk
hi thanks for your time,the cable seems ok,i have tried my old dm800 and that wont pick up anything either, there is no signal whatsoever but i can move the motor
thanks
If you were in a location affected by the winds this week potentially the dish is out of alignment now
If the motor is moving the next steps would be to check the cable between the motor and LNB and dish alignment.
spitfire1500
05-01-17, 20:48
It's one of 3 things as no signal is being received,
1) dish alignment...............Check the mount is vertical then move the dish East - West on a strong transponder to check for a signal
2) Cable..........................Check all F connectors between the receiver and LNB and the cable condition
3) LNB.............................Check the condition of the LNB for sign of damage or water penetration and replace if necessary
SF1500
thanks for all your help, the lnb cable had come loose from the f connector, all fixed now
thanks :thumbsup:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.