PDA

View Full Version : hotbird 13 east


nasser007
15-05-10, 10:59
I have the openpLi image on my box and have scaned hotbird 13east its does`nt seem to pick up all channels but when using a different receiver it scans the the lot anyone else come across this?
Retired member
15-05-10, 11:04
Give us a little more information on this.... What setup do you have, fixed dish, monoblock, motorised etc. and what config do you have the tuner(s) set to. I'd guess its a tuner config problem but if you give us a bit more info sure we can get to the bottom of it :)
Sicilian
15-05-10, 11:05
See attached screenshot. Make sure you set type of scan to single satellite and set the correct satellite to hotbird 13deg.

http://www.vuplus-support.co.uk/attachment.php?attachmentid=333
nasser007
15-05-10, 11:08
i`ve done that still missing alot
OldSkulRide
15-05-10, 11:17
update satellites.xml file
nasser007
15-05-10, 11:26
new to this how do you do that mate
nasser007
15-05-10, 11:38
I am using a motorised system and tuner A:BCM7335 DVB-52 NIM INTERNAL positioner usals
Retired member
15-05-10, 12:07
Ok what image are you using at the moment? To save a while why not take a look at this thread here http://www.vuplus-support.co.uk/showthread.php?360-VuPlus-Support.co.uk-OpenPLi-powered-backup-image-for-newbie%E2%80%99s and you will probably be fully up and running in no time.
nasser007
15-05-10, 12:13
thank you will try that
nasser007
15-05-10, 13:10
followed instructions so far good, but scanning astra and hotbird seems to take forever is this right
Retired member
15-05-10, 13:54
Well yes could well do, there are hundreds and hundreds of channels between these two sats, but to save time again rather than doing a manual scan why don't you take a look at the E2 settings in the forum here, if you transfer these to the VU+ it'll save you all the time of having to scan them all in and they'll be in a nice grouped order as well.... I like catseye settings personally but there are a few you can give a go to see what suits you.
nasser007
15-05-10, 16:10
am new to all this any help in showing how to transfer to the vu + please.
Sicilian
16-05-10, 05:32
am new to all this any help in showing how to transfer to the vu + please.

You can use Dreamboxedit to transfer setting/bouquets to your VU+ Duo.

Theres a manual here http://www.vuplus-support.co.uk/showthread.php?27-DreamBox-Edit-How-to-manual Dreamboxedit here http://www.vuplus-support.co.uk/showthread.php?12-DreamBoxEdit-3.0.0.0 and here's a screenshot of the correct settings, just change the IP to suit your receiver.

http://www.vuplus-support.co.uk/attachment.php?attachmentid=336

Finally here's a load of Enigma2 settings that you can try http://www.vuplus-support.co.uk/forumdisplay.php?21-Enigma-2-Settings
nasser007
16-05-10, 10:02
thanks alot m8 you are very helpful