View Full Version : VU 4K Cable setup
I have just connected a cable from the NTL box on the wall to the reciever, did a scan for channels and get ' scanning failed' message up not a single channel
in the setup do I need to alter things I have:
Freq , Symbol rate , Modulation , Network ID , Use offical channel numbering , HD List and Enable auto cable scan
Have checked the cable and connectors outside and all ok.
I am in the Teesside area if this helps
Use ABM and set your net id for your area.
Use ABM and set your net id for your area.
Thanks - just got that info now waiting for the TV back after the soaps :rolleyes:
Just entered the info and still the same - 'scanning failed'
Do i need any addition file(s) and or to change / edit other details
Have you had the virgin tv working prior on another box?
Please post a photo of how you have the cables connected at the back of the receiver.
Just double checked and no signal at all in signal finder , checked cable at both ends so guessing it's been cut outside somewhere. I will be in the garden most of the day so will be looking deeper
will write back 2moro
So have you had Cable tv working before? and as Huevos as asked are you connecting to the correct input (rf in- using adaptor)
This is the first time I have used cable , just moved into the property (have the sly setup and running) the rf is connected with cable tuner installed bought from sponsor 2 weeks ago
Please post a photo of how you have the cables connected at the back of the receiver.
Photo of cables at back of box49609
I see what you've done. You've put a normal RF in connector on the end of your cable cable. Didn't know you could do it this way. I have always used the cable to Rf adaptors.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.