View Full Version : Fan Control Xtrend ET8500?!
beaudaniels
27-07-16, 11:48
Hello members :)
Just our of curiosity really, but the fan on my Xtrend ET8500 - Is it supposed to be on constantly even when set to auto?
I assumed that when cool enough it would turn itself off?
Woke up this morning, went downstairs and it was still going....... :confused:
I have fan-auto, watch system temp on, switch ON on system temp 40
Works for me.
Copied your setting. Cant hear my fan running in my ET8500 so must be quiet.
FP
beaudaniels
27-07-16, 20:31
I have fan-auto, watch system temp on, switch ON on system temp 40
Works for me.
Just changed mine to this as well.....
:)
Have tried same settings but have not noticed any difference as in I can still hear fan constantly.System temperature always reads 36° when ever I check so am not sure if that is too high or O.K.Am wary of lowering initial fan speed too much
I have my initial fan speed turned down so its just under the last n in extensioNs and its not been an issue for my boxes.
If its too low the system temp check will push it up..... but have only noticed it when our temps were consistently over 35 C last year:)
I have fan-auto, watch system temp on, switch ON on system temp 40
Works for me.
Fan is constantly on even under 40º using these settings on my setup.Have changed to fan-off,which is less annoying.Have put notebook cooler underneath which is silent compared to et8500 fan(temp stays too low to kick in).Will try swapping stock fan with Noctau 40mm but would anyone know voltage of stock fan 5v or 12v?
I set mine to off in standby. Takes approx 2-3 mins to switch off once in standby.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.