View Full Version : Xtrend 8000 Not pausing or recording
CU CHULAINN THE BRAVE
10-05-16, 16:41
Hi, My Xtrend 8000 has a 250gb hard drive installed. But lately the pause and record feature has stopped working. I think my memory may be full and causing the problems. Can someone please tell me how I can check the memory and how to delete it as well? Or might there be some other fault causing the problems? Many thanks
Andy_Hazza
10-05-16, 16:45
Have you deleted the recordings out of your trashcan also?
Sent from my iPhone using Tapatalk
abu baniaz
10-05-16, 16:47
Menu > Information > Devices
You should see the HDD listed with capacity details. Post a screenshot of it.
CU CHULAINN THE BRAVE
11-05-16, 07:46
Thanks guys, here's a few screenshots...4812248123
On a separate note, the sound has went off on all my HD channels. Can this be fixed?
Many thanks as always.
Your hard drive is not mounted/connected
CU CHULAINN THE BRAVE
11-05-16, 08:26
I wonder how that would have happened? All used to work fine. If I take the case off how do I identify the hard drive to remount it?
Do you have any idea why the sound isn't working on my HD channels?
Thanks
Just try to re initialize hdd via settings. No need to open box.
CU CHULAINN THE BRAVE
11-05-16, 08:59
Great. The hdd is re initialized and the record feature is now working again. But the pause button is still not working. Can you please help me to fix this?
Many thanks
Start timeshift again in settings
abu baniaz
12-05-16, 09:23
Did you change the timeshift path? If so, put it back to the default setting. (The same path is use whether timeshift is started automatically or manually.)
CU CHULAINN THE BRAVE
24-05-16, 15:14
Finally got it sorted. Thanks guys
Rob van der Does
24-05-16, 17:01
How ?
I wonder how that would have happened? All used to work fine. If I take the case off how do I identify the hard drive to remount it?
Do you have any idea why the sound isn't working on my HD channels?
Thanks
On my Extrend 10000 which I normally put into deep standby the hard drive will "go missing " about once every two months. I usually notice when I get an on screen message saying that the hard drive is full. Thus message occurs because the box is only seeing the small USB stick I have permanently plugged in.
The fix that always works is switching off at the mains for a few minutes and then switching back on. Attempting to re-mount the disk when missing is not an option because the box doesn't believe one is attached to the cables!
My ET10k invariably loses the HD sometime soon after reflashing.
I always power off at the mains for half an hour after upgrading, and the HD then always (touch wood) gets picked up ok.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.