Startup Channel

[peterthepainter]

Hi.
When I bring the box out of Standby there is no channel selected, just " ---- " on the front display, and a "no signal" message on the TV. If I up, or down shift channel on the remote it comes up, but not on a channel anywhere near the pre-set Startup Channel.
Any suggestions much appreciated.

[judge]

Your 'pre-set Startup Channel' no longer exists on that frequency?
How are you shutting down your box?

[peterthepainter]

I've simply been pressing Standby on remote. I've tried changing the startup channel with the same result. I've just re-scanned all the channels after the box has been idle for 12 months and this problem has arisen. But I can see your logic, I'll try again, and maybe I can revert to no startup channel and see if that makes a difference. Will report back.