Mediatomb requires libav but not available anymore

[karsta]

So libav is replaced by ffmpeg? Mediatomb plugin requires libav.
So, to be able to still stream live TV to DLNA clients, do I have to go back to version 3, or could you bring libav back?

[karsta]

Isn't anyone else using mediatomb for dlna-streming?

[DaMacFunkin]

Is anyone else using dlna steaming might be a better question.

[karsta]

Sorry about my typo and bad english and that I thought this was an openvix support forum.

[karsta]

ok, forget mediatomb. Is there a chance to get libav back?

[c_rothwell]

As above please "Is there a chance to get libav back?"

[bbbuk]

Looking at the dependencies for this and what's available from feeds, the following two files aren't available from the feeds:-
libavformat53
libavutil51
However, you could try installing the following two files (available from feeds) which may work:-
libavformat57
libavutil55
This is done via telnet commands:-

opkg update
opkg install libavformat57
opkg install libavutil55

If you get no errors installing these two files then install mediatomb plugin using following command (assuming you have already FTP the plugin to "/tmp" folder):-


opkg --force-depends --force-reinstall --force-maintainer --force-overwrite install /tmp/*.ipk

All this is just a theory and therefore can't be relied upon to not cause more issues with your image. I therefore recommend you make a full image backup so you can flash back to this in case of image problems.

[c_rothwell]

Hi bbbuk,
Thanks but that doesn't work, same error meesage

[bbbuk]

What exactly does error message state and is at whilst trying to install mediatomb plugin itself or whilst trying to run the plugin (if that's at all possible)?

[c_rothwell]

Hi, error:
Cannot satisfy the follow dependencies for enimga2-plugin-extensions-mediatomb: libav *

[abu baniaz]

I don't think the plugin is compiling. Maybe someone else can check?

[karsta]

Thanks! I might give it a try. I already reverted to the older version, but sooner or later...

[bbbuk]

Hi, error:
Cannot satisfy the follow dependencies for enimga2-plugin-extensions-mediatomb: libav *does it actually state libav * or does it state the two files I mentioned in post 7 ?

[abu baniaz]

When I unpack the ipk, it is blank. When I unbuild the ipk, it is just a control file. Went through a few images, same result.


Below is the installation process while on Hades


root@tmnano3t:~#opkg install enigma2-plugin-extensions-mediatomb
Installing enigma2-plugin-extensions-mediatomb (0.12.1-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/enigma2-plugin-extensions-mediatomb_0.12.1-r0_mips32el.ipk.
Installing libexif12 (0.6.21-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libexif12_0.6.21-r0_mips32el.ipk.
Installing mozjs (24.2.0-r1) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/mozjs_24.2.0-r1_mips32el.ipk.
Installing nspr (4.10.8-r1) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/nspr_4.10.8-r1_mips32el.ipk.
Installing id3lib (3.8.3-r1) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/id3lib_3.8.3-r1_mips32el.ipk.
Installing file (5.22-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/file_5.22-r0_mips32el.ipk.
Installing sqlite3 (3.7.13-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/sqlite3_3.7.13-r0_mips32el.ipk.
Installing libav (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libav_9.16-r0_mips32el.ipk.
Installing libavcodec54 (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libavcodec54_9.16-r0_mips32el.ipk.
Installing libtheora0 (1.1.1-r3.1) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libtheora0_1.1.1-r3.1_mips32el.ipk.
Installing libx264-133 (r2265+git0+ffc3ad4945-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libx264-133_r2265+git0+ffc3ad4945-r0_mips32el.ipk.
Installing libavutil52 (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libavutil52_9.16-r0_mips32el.ipk.
Installing libswscale2 (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libswscale2_9.16-r0_mips32el.ipk.
Installing libsdl-1.2-0 (1.2.15-r3) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/dags4/libsdl-1.2-0_1.2.15-r3_dags4.ipk.
Installing libts-1.0-0 (1.0+gitr0+e17263ef40-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libts-1.0-0_1.0+gitr0+e17263ef40-r0_mips32el.ipk.
Installing tslib-conf (1.0+gitr0+e17263ef40-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/tslib-conf_1.0+gitr0+e17263ef40-r0_mips32el.ipk.
Installing libavformat54 (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libavformat54_9.16-r0_mips32el.ipk.
Installing libavresample1 (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libavresample1_9.16-r0_mips32el.ipk.
Installing libavfilter3 (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libavfilter3_9.16-r0_mips32el.ipk.
Installing libavdevice53 (9.16-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libavdevice53_9.16-r0_mips32el.ipk.
Installing libxfixes3 (1:5.0.1-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libxfixes3_5.0.1-r0_mips32el.ipk.
Installing libxext6 (1:1.3.3-r0) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/libxext6_1.3.3-r0_mips32el.ipk.
Installing pointercal (0.0-r11) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/dags4/pointercal_0.0-r11_dags4.ipk.
Installing mediatomb (0.12.1-r7) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/mediatomb_0.12.1-r7_mips32el.ipk.
Installing js (1.7.0+1.8.0rc1-r4) on root.
Downloading http://www.openvix.co.uk/feeds/openvix/Hades/dags4/mips32el/js_1.7.0+1.8.0rc1-r4_mips32el.ipk.
Removing any system startup links for mediatomb ...
Configuring sqlite3.
Configuring libtheora0.
Configuring libx264-133.
Configuring libavutil52.
Configuring libavcodec54.
Configuring libswscale2.
Configuring tslib-conf.
Configuring pointercal.
Configuring libts-1.0-0.
Configuring libsdl-1.2-0.
Configuring libavformat54.
Configuring libavresample1.
Configuring libavfilter3.
Configuring libxfixes3.
Configuring libxext6.
Configuring libavdevice53.
Configuring libav.
Configuring js.
Configuring libexif12.
Configuring nspr.
Configuring mozjs.
Configuring id3lib.
Configuring file.
Configuring mediatomb.
Adding system startup for /etc/init.d/mediatomb.
Starting upnp media server: mediatomb.
Configuring enigma2-plugin-extensions-mediatomb.
root@tmnano3t:~#

[karsta]

Finally. I got mediatomb installed to v. 4.1.016 like this:

Download all libav* files (excluding libavahi*) with "wget" from
http://openpli.ido.cz/openpli-4/mips32el/

to some directory of your choice in vu.
cd to that directory and execute as root:

"opkg install ./libav*"

You'll get one error, but it's ok. Then install mediatomb plugin and it works.

[brackb01]

Hi

I've tried wget http://openpli.ido.cz/openpli-4/mips32el/ libav*

however I get server returned error: HTTP/1.1 404 not found

help?

[karsta]

You have an extra space before the filename and wget does not support wildcards and the page has disappeared apparently.

Go here:
http://fam.8a8f8.com/download/vubox/OpenPLi4.0/3.1.1/mips32el/
and copy the url of each needed file and wget them separately.

Anyone managed to get mediatomb working with 4.2 by the way?

[brackb01]

Thankyou, but i'm not sure which ones I want, should i just get all the ones that say libav?

[brackb01]

Scrub that, working nicely on 4.2.021. thanks so much!

[karsta]

Scrub that, working nicely on 4.2.021. thanks so much!

Cool.
Those were older versions than the ones on the disappeared site, but i'm glad it works for you.

[IAmATeaf]

Did you get 021 online as an upgrade, on my et10000 I've still got no notification of an available upgrade.

[karsta]

From here newer ones:
http://melodie.ido.cz/openpli-4/mips32el/
Actually it's the original site that has come back from dead.