View Full Version : [VU+ Zero] Black screen after flash
Hi. I received my Vu Zero but it was delivered with orioginal firmware and not openvix. I downloaded openvix 3.2.037 and tried to flash. It seemed to follow the flash process but repeatedly stayed on slow flashing LED for 30 mins. Guide says it should take 2-4 mins and ok to power off after 10 minutes. Rebooted and initial boot screen appeared but soon went off then just a black screen. Front LED flashes if i press the remote control buttons but no picture, tried with Openvix 3.2.036 but still the same. It seems to go through the flash process but does not seem to boot new image, any ideas?
This site sponsor - will it need the new bootloader?
Follow this guide m8 >>>>>>>>>>>>>>http://www.world-of-satellite.com/showthread.php?44889-How-to-flash-a-Vu-Zero&highlight=HOW+FLASH+ZERO
?H
Hi, thanks for the link. Thats the link I followed when flashing the Vu Zero. I am going to try and load the bootlader from Feb 2015 see if that helps. Flashing back to default Vu image worked ok its only when trying to flash openvix 3.2 I have issues and black screen. Responds to remote clicks though which seems like its booting but no video output. I even tried the RCA output and still black screen so that eliminates problem with HDMI.
Hi. Tried updating bootloader and installing openvix again. It starts the update process and the white LED fades in and out. Left it for 30 mins and still the same. Tried 3 different USB sticks and none would finish the process. I rebooted the box and it loads the initial splash screen then goes black, again the LED will flash when i press the remote. When i flash the Vu default firmware back on it works. Am I doing something wrong? or any ideas? Thanks
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.