blackhole vu+duo 1.4.2 multiboot

[sukhvi]

hi,iv got the vix 1.3 in flash with barry allen and put the bh 1.4.2 in barry allen multiboot.the blackhole image runs fine but when i go to start ccam 2.2.1 it says blackhole image must be in flash.i thought this was suppossed to be the multiboot version?? is there any way i can try the blackhole image in multiboot?

[ols732]

in my opinion this new image (BlackHole 1.4.2 ) have new drivers (21/12/2010) and i think this is the problem.
you try in multiboot with BlackHole 1.4.1 ?(if BlackHole 1.4.1 works fine, then is 100% drivers problem )

[stingy]

Please, how can I install Emu Cccam 2.2.1? Thanks a lot

[ols732]

with DCC put in tmp E2_CCcam_2.2.1_DE.tgz and after green button >yellow button> Manual install Bh packges> ok>.....and folow the screen instruction

[unisat]

hi,iv got the vix 1.3 in flash with barry allen and put the bh 1.4.2 in barry allen multiboot.the blackhole image runs fine but when i go to start ccam 2.2.1 it says blackhole image must be in flash.i thought this was suppossed to be the multiboot version?? is there any way i can try the blackhole image in multiboot?

To activate ccam 2.2.1 do the following:

1/ Edit file named " Bhcamconf" in /etc as follows:


delcurrent|/usr/camscript/Ncam_CCcam2.2.1.sh
deldefault|/usr/camscript/Ncam_CCcam2.2.1.sh


just define which camscript is current and default in this case its "Ncam_CCcam2.2.1.sh" , and reboot.

regards