View Full Version : [VU+ Solo2] After updated to 3.2.014
After updated to 3.2.014
452564525745258
What this?
What did u update from and have you tried a double update?
Sent from my iPhone using Tapatalk
i update from 3.2.013
i don't tried a double update.
Hi, I also had the same, and just tried the double update - but it stays the same (2 packages to update) after the 2nd update.
I then also checked in the official download location, but the 014 version is not available as image-download for the Solo2.
Any ideas ?
snoopy2013
20-10-15, 06:59
Good morning,
I can also confirm:
After updating to build 014, still remaining 2 packages and update indicator is still blinking ...
Regards
What was the last time you guys fresh flashed?
Andy_Hazza
20-10-15, 07:34
Do you have Ocram picons installed? This most likely your problem.
Sent from my iPhone using Tapatalk
i have same issue, no oscam picons just MK. I did a fresh flash for the new 3.2 001
DaMacFunkin
20-10-15, 08:02
You needed to do a fresh flash for 090 as well, this was announced, reported and re-reported many times over the last few weeks.
Rob van der Does
20-10-15, 08:04
Only the telnet command
opkg update && opkg list-upgradable
will tell you what's available.
DaMacFunkin
20-10-15, 08:35
Sorry meant 009
odd, just came home and the update notice has gone?
snoopy2013
21-10-15, 13:28
Hi,
solution was for me (post #3 in the following thread in Forum OpenPli):
http://forums.openpli.org/topic/39174-upgrade-error/#entry509896
Regards
Upgraded and now boot up takes so long I can make tea and toast !!! ####ing slow
Sent from my Blade S6 using Tapatalk
Hi,
solution was for me (post #3 in the following thread in Forum OpenPli):
http://forums.openpli.org/topic/39174-upgrade-error/#entry509896
Regards
Worked for me too.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.