vu+ duo2 very slow vix logo spinning very often

[eddiq]

hi
I have a problem with my duo2 which is working very slowly, nearly every time I try to change the channel vix sign spins on the top left corner for about 20-30 seconds then the channel changes, just had a reflash of image vix3.2 build 003 with no restore backup, just replaced autotimers.xml from old image. I did try hades image 18 before this but this did not work either.

drivers 2015-06-23
installed 2015-08-26
last update 2015-08-24

[Stanman]

Usb or HDD attached?

Try removing and than adding if issue resolved.

D2 here and no spinners.

No picon on HDD

[eddiq]

thanks for a quick response.
I have 1tb 2.5hdd inside but I hade that for nearly 1 year with no problem, no picons, problem started after update,
will try removing hdd and report.

[DaMacFunkin]

I upgraded my duo2 to 3.2 yesterday running bello skin and I must say it feels sluggish and I did notice the spinner regularly for no apparent reason.

[stevesom]

I know this isnt a duo but have had the same on my et10k spins i have to knock it off on the rear as it does not respond on 3.2

[Huevos]

So this is a completely virgin image you are testing? No restore or plugins have been added?

[stevesom]

I initially restored plugins by mistake so done a fresh flash and havent loaded any plugins or settings back up.

[s2tephen]

I have installed 3.2 and now the boot time is twice what it was with the last hades version.
Clean install No restore.
But it works WHEN its loaded.
VU+ Duo2.

[eddiq]

I have done fresh install and no restore but I have copyed autotimer.xml and timers.xml in to ect/enigma2

[eddiq]

thank you, Stanman you were right hdd fault, I have formatted now and it work's fine