View Full Version : Technomate TM Twin Change image
K.Withnage
10-05-15, 17:45
Now I am using OpenPli ,I would like to install openVix in to my receiver,I already down load it,Please tell me how to up load openVix & Weather should I delete openpli & install new one????
Andy_Hazza
10-05-15, 17:50
Format a usb to fat32, extract the file onto your usb and insert it into your receiver and turn your box on and follow the instructions onscreen. Simples.
Sent from my iPhone using Tapatalk
K.Withnage
18-05-15, 16:35
Now I am facing another problem,Receiver will start normally ,after one or two minute will start freezing Please help me to solve this problem.Attached ss with this.42628
Now I am facing another problem,Receiver will start normally ,after one or two minute will start freezing Please help me to solve this problem.Attached ss with this.42628
Flakey HDMI cable?
abu baniaz
18-05-15, 18:14
It is possible you had teh older bootloader onyour Twin. Flash the latest one.
I think I have seen this as abu has said. I think this is the latest boot load here.
http://www.openvix.co.uk/index.php?dir=Bootloaders/Technomate-Bootloaders/TM-TWIN-OE/
and then flash hades 008
K.Withnage
20-05-15, 09:53
HDMI cable is OK.
K.Withnage
11-06-15, 13:42
My.Technomate Twin OE Again problem.2 week I did not use it,Power of & kept it,After 2 week Receiver cannot start,It is only display starting ,but no.I try to install latest boot loader & image but same thing happen Only display starting. I change usb port & usb stick several time, also nothing happen.Please help me solve this problem.
abu baniaz
11-06-15, 13:50
Ring Technomate.
May need jtagging and PSU is possibly on its way out.
K.Withnage
12-06-15, 01:19
Please explane jtagging & PSU. Thanks
abu baniaz
12-06-15, 01:21
PSU= Power supply unit
Jtagging= They connect wires to receiver and program a file that way. You can then flash image normally
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.