PDA

View Full Version : [GiGaBlue HD800SE+] Isn't flashing new image


Mister786
28-03-15, 02:37
Hi guys. Ive been trying to flash my box to 160 (latest firmware) from 138 but it's not doing it. I load the fat32 formatted usb with the gigablue folder for update of the seplus but it just boots up to the previous firmware. Is there anything I'm missing?
judge
28-03-15, 02:43
Blue button -> ViX -> Image Manager -> Yellow button, to download current released builds.
Exit out of menu.
Blue button -> ViX -> Image Manager, and select the image you want to flash.
Mister786
28-03-15, 02:58
But I was under the impression from build 155 onwards you needed a fresh flash?
judge
28-03-15, 03:26
But I was under the impression from build 155 onwards you needed a fresh flash?
Yes, above method does it in the most simple way.
Mister786
28-03-15, 11:00
Alright thanks. I'll give it a go. :)
Mister786
28-03-15, 11:48
Hi. I've tried that but it isn't showing up with any images to download?
oldbill
30-03-15, 19:54
Blue button -> ViX -> Image Manager -> Yellow button, to download current released builds.
Exit out of menu.
Blue button -> ViX -> Image Manager, and select the image you want to flash.

sorry for butting in guys, it is telling me to reformat and try again
abu baniaz
31-03-15, 00:46
But I was under the impression from build 155 onwards you needed a fresh flash?
Once you are on 155 or higher, you can perform an online update.
Tkr001
31-03-15, 04:49
What Judge says to do in post #2 is a fresh flash same as flashing from usb stick. It is just an easier way to flash.
Tryharder
31-03-15, 13:44
Hi guys. Ive been trying to flash my box to 160 (latest firmware) from 138 but it's not doing it. I load the fat32 formatted usb with the gigablue folder for update of the seplus but it just boots up to the previous firmware. Is there anything I'm missing?

It may be obvious but are you pressing the OK button on the front panel after inserting the USB stick as you switch on at the back? also make sure no other usb ports have anything inserted and there arent any other files on the stick....

rgds. Tryharder
Mister786
07-04-15, 00:58
It may be obvious but are you pressing the OK button on the front panel after inserting the USB stick as you switch on at the back? also make sure no other usb ports have anything inserted and there arent any other files on the stick....

rgds. Tryharder

isnt OK pressed when the display shows CONF? In my case the front display just loads to a 100 and then boots to the previous firmware.