CraigW
07-11-14, 01:00
Hi guys,
I'm new to Linux boxes, i've had the likes of skybox/openbox before...
I have just purchased a GiGaBlue Quad Plus HD box and flashed it using the Stock ViX image
http://www.openvix.co.uk/index.php?dir=GiGaBlue-HD-QUAD-PLUS/&file=openvixhd-Apollo.073-gbquadplus_usb.zip
I have the 2 x built-in DVB-S tuners and also a DVB-C tuner for cable. Standard fixed dish, no motor.
When starting the box, it boots ok and starts the install wizard. I have gone through the option and when it gets to the first tuner DVB-S it hangs.
Once restarted, it goes straoght the the channel (obviously blank)
Upon going into Menu -> Setup -> Service Searching -> Tuner Configuration and setting the tuners to this setting:
Tuner A
Configuration mode - Simple
Mode - Single
Satellite - 28.2E
Tuner B
Configuration mode - Simple
Mode - Single
Satellite - 28.2E
Tuner C
Tuner Type - DVB-C
Configuration Mode - Enabled
Network ID - 40966 (Knowsley 2)
Used Service scan type - Provider
Provider to scan - Virgin Media UK (6952)
I then go to AutoBouqetsMaker and select the providers I want (S*y UK, Virmin Media UK and S*y NIRL)
Then Start Scan, all I get then is Cannot read data. Every time. I am setting this box up from new, is there something i'm doing wrong?
If I do a manual scan on tuner A, B or C, it picks ALL chanels up fine
I'm new to Linux boxes, i've had the likes of skybox/openbox before...
I have just purchased a GiGaBlue Quad Plus HD box and flashed it using the Stock ViX image
http://www.openvix.co.uk/index.php?dir=GiGaBlue-HD-QUAD-PLUS/&file=openvixhd-Apollo.073-gbquadplus_usb.zip
I have the 2 x built-in DVB-S tuners and also a DVB-C tuner for cable. Standard fixed dish, no motor.
When starting the box, it boots ok and starts the install wizard. I have gone through the option and when it gets to the first tuner DVB-S it hangs.
Once restarted, it goes straoght the the channel (obviously blank)
Upon going into Menu -> Setup -> Service Searching -> Tuner Configuration and setting the tuners to this setting:
Tuner A
Configuration mode - Simple
Mode - Single
Satellite - 28.2E
Tuner B
Configuration mode - Simple
Mode - Single
Satellite - 28.2E
Tuner C
Tuner Type - DVB-C
Configuration Mode - Enabled
Network ID - 40966 (Knowsley 2)
Used Service scan type - Provider
Provider to scan - Virgin Media UK (6952)
I then go to AutoBouqetsMaker and select the providers I want (S*y UK, Virmin Media UK and S*y NIRL)
Then Start Scan, all I get then is Cannot read data. Every time. I am setting this box up from new, is there something i'm doing wrong?
If I do a manual scan on tuner A, B or C, it picks ALL chanels up fine