View Full Version : [ET10x00] Boot loop on build 070 (HD version) after software update
Just tried siftware update on build 064 ( because of problems with dual ethernet connection)
Will try flash later tonight when i have time - but this is to indicate probblems with software update
Found time to flash and it works fine...... So NO software update! :confused:
Hi,
bootloop often means crash. Do you have a crashlog?
ciao
Hi,
bootloop often means crash. Do you have a crashlog?
ciao
No - and it is set up to send by email, so it didn't get as far as fully initialising the system. .
So would have to go through the special procedure to send the log (init4, enigma2 etc) and I have since re flashed OK..... I was very tight on time last night.
So not a good answer, but it has convinced me to always download the image zip and re-flash online.... although on the ET10000 it just means re-booting 3 times to get everything back from restore settings:)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.