View Full Version : tm nano t3
just put a vix image on my new tm t3 iv got it connected to a vbox but im stiuggling to set it up to work with the tm nano 3 I had the vbox connected to my tm 5402 and it worked great I don't no what im doing rong could some boday help me with this please
abu baniaz
28-10-14, 23:06
What settings have you used in tuner config?
tune a then 1.2 and universal lmb
abu baniaz
28-10-14, 23:35
I am pretty sure you have to use Advanced setup and ensure that the position numbers match thoses that are programmed in the vbox. Have a look at section 1.5 of the Vix manual.
iv do all of that got it in advanced and matched the numbers from the vbox to the tm 3 still nothing I saved every thing to like it tells u to
abu baniaz
28-10-14, 23:48
What have you set your second tuner as?
Please also upload your settings file. It is located in /etc/enigma2
iv do all of that got it in advanced and matched the numbers from the vbox to the tm 3 still nothing I saved every thing to like it tells u to
38047
http://www.newyorker.com/humor/daily-shouts/write-sentence
thanks for that ill give a go to morrow ill read the manual ill let u no how I go on thanks again
thanks for that ill give a go to morrow ill read the manual ill let u no how I go on thanks again
Please do. If you require support, typing in readable text is a lot easier to provide support on.
How Abu was able to make sense of anything in that sentence is beyond me & I speak in English. Imagine how hard it would be for any non English speakers.
thanks for that ill give a go to morrow ill read the manual ill let u no how I go on thanks again
Also, if you can't type in readable English while typing in English, please let us know so no sarcastic replies are required.
how you can have a favorite list of channels on tm nano t3 please and how to flashes biss keys
abu baniaz
29-10-14, 23:29
how you can have a favorite list of channels on tm nano t3 please and how to flashes biss keys
We dont do biss keys talk here.
how you can have a favorite list of channels on tm nano t3 please
Thank you
Hi to all.. any help from someone for nano t3 please
abu baniaz
31-10-14, 22:36
There is no special way for the receiver. It is same as all E2 receivers. Use DreamboxEdit or similar programs.
ABM also "scans"/creates for several providers
i have set the name server on cccam 2.2.1 /connected but not clear any channels
i have done it with DCC v2.95
any help pls
i have this receiver nano t3 for two weeks and only fta channels nothing works image vix any help pls new to e2
I had the same thing when I did a scan
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.