Change video output from remote?

[sebus]

Have been using this image for months.
Always worked perfect, but recently unit comes on, start screens are visible & the moment channel comes on TV goes blue (no signal) - possibly the unit is failing...

HDMI connection to HD TV

I can use webinterface & its remote control to navigate to AV settings, change output to SCART (not even connected!), at which point picture comes back on TV (with question "Is this resolution OK?") and I can carry on with No & it reverts back to HDMI & works perfectly again for the session

Question: is there a way to change video output with key combination (without going through menu, which is not visible on TV)

Thanks

sebus

[sebus]

It only happens on channels that do not clear on boot. Changing (blind, just using numberpad) to FTA channel brings the picture back (most odd behaviour)

sebus

[sebus]

Was this possibly adjusted in later builds?