snoopy2013
27-08-14, 09:55
Hi,
with my Solo2 I have since the new kernel and the new drivers unfortunately always problems with the gigabit network (sporadic dips in the speed). :(
After set the interface limited to 100 Mbit/s (telnet: "ethtool eth0 speed 100 duplex full -s autoneg on") there are no more problems. :)
I would therefore now automatically change the network speed (till the driver issues are resolved) when booting the box.
I now therefore simply writtern a very simple scipt "network100mbit.sh" with content:
#! /bin/bash
ethtool eth0 speed 100 duplex full -s autoneg on
and then executed with this attribute (755) copied into the directory "/etc/init.d" and then linked to this in "/etc/rs.Sd":
"ln-s /etc/init.d/network100mibt.sh S99network100mibt.sh"
After rebooting the box output of "ethtool eth0" but then shows still 1000Mb/s ... :confused:
When I use the script "network100mbit.sh" manually by remotecontrole using "dream explorer", the speed is changed, however.
Does anyone have an idea where my mistake is that the script is not run automatically when booting the box?
Would be very grateful for any help.
Regards
PS:
Please excuse my bad english!
with my Solo2 I have since the new kernel and the new drivers unfortunately always problems with the gigabit network (sporadic dips in the speed). :(
After set the interface limited to 100 Mbit/s (telnet: "ethtool eth0 speed 100 duplex full -s autoneg on") there are no more problems. :)
I would therefore now automatically change the network speed (till the driver issues are resolved) when booting the box.
I now therefore simply writtern a very simple scipt "network100mbit.sh" with content:
#! /bin/bash
ethtool eth0 speed 100 duplex full -s autoneg on
and then executed with this attribute (755) copied into the directory "/etc/init.d" and then linked to this in "/etc/rs.Sd":
"ln-s /etc/init.d/network100mibt.sh S99network100mibt.sh"
After rebooting the box output of "ethtool eth0" but then shows still 1000Mb/s ... :confused:
When I use the script "network100mbit.sh" manually by remotecontrole using "dream explorer", the speed is changed, however.
Does anyone have an idea where my mistake is that the script is not run automatically when booting the box?
Would be very grateful for any help.
Regards
PS:
Please excuse my bad english!