Apollo 024 No dB in SNR, only %

[huve]

In Apollo 023 SNR dB worked, Apollo 024 the Swap SNR % with SNR in dB does not work. My guess is the new drivers in 024. Usually new drivers break something that worked in previous version.

[nsw9154]

just tried it on my Duo2 with BT Sports 1 SNR 10.2db AGC 69% so it seems to be working

[huve]

I forget to say that the problems is in Gigablue Quad. If it works in Duo2, it's the usual suspect Gigablue drivers.

[nsw9154]

then again I have just tried it with my LX3 and it is not working either it still shows BBC1 SNR 82% and AGC 99% and no db reading but I always use the % so not a problem for me

[Alec]

I have a Giga Quad over a year, and the SNR has never worked properly. No matter what Image I used on it. It is now on apollo 23 and it is still all over the place. I have other receivers and the SNR worked as it should.

[rossi2000]

my quads snr is all over aswell for a long time

some sats show -2% lol but work fine :)

[huve]

They got dBs in Quad a year ago, since that there has not been BER (allways zero), before there was BER, but no dBs. And dBs are incorrect. For DVB-S QPSK 2/3 (used at 28.2E) you need a 4.81 dB for a quasi error free picture and I had a error free picture at 4.0 dB, at 3.5 dB it is breaking in Quad.

Also the percents (no dBs) in the c/t tuner are useless. I used a adjustable attenuator in DVB-C to see at what values I lose picture. The scaling is useless, I started from SNR 87%. QAM256 had perfect picture at 59%, started to pixellate at 59% and screen was black at 59%, for QAM128 it is 46%. It really hard to figure out if one has a problem from a low SNR if you can have or have not a picture at the same SNR value. Also the c/t-tuner is not very sensitive and the loop-thru (cable from tuner C to tuner D) has high attuation. Because of that I had to put a 1:4 splitter, one to tv, two to quad and one to old twin tuner cable box.