invader7
29-07-14, 08:52
Hello , i have a gigablue 800 HD SE receiver and the problem im facing is that when the power is cut suddenly then the receiver doesn't come up , it stays at "boot" and no image !
I have to leave it out of power for a loooooooong time and then it comes up !
Yesterday i tried to change the bootloader and update its firmware, now i have bootloader 08_08_2012 and OpenMips_4.1
The problem is the same except i have to wait ~2-5 minutes off power and then it comes up !
If i close the receiver from its button or from the remote , it works as supposed with no problem , but when power is cut i'm facing the issue.
Is there a workaround for this ! Its very annoying issue !
Thanks !!!!!
I have to leave it out of power for a loooooooong time and then it comes up !
Yesterday i tried to change the bootloader and update its firmware, now i have bootloader 08_08_2012 and OpenMips_4.1
The problem is the same except i have to wait ~2-5 minutes off power and then it comes up !
If i close the receiver from its button or from the remote , it works as supposed with no problem , but when power is cut i'm facing the issue.
Is there a workaround for this ! Its very annoying issue !
Thanks !!!!!