Software Error Message-Cannot start VU+Solo2£

[RottyDave]

35505Hello all,

Trouble began last night as I lost all

sound when I powered up the receiver from standby.
The only way his could be rectified was by turning the power off and back on which never fails to restore sound but is most annoying.

My Vu box will now not start up at all and it only ever gets as far as the screen dump that I've attached!
If any one could give me a little guidance I would be grateful,

Regards

[abu baniaz]

You have filled up flash memory, quite possibly inadvertently saving EPG to internal memory.

Best to reflash if you can't delete EPG.DAT.

[RottyDave]

Ok Abu,thanks 4 the advice-I will try that.
I haven't reflagged it since this time last year when
You advised how to set up initially so by reflashing do you mean
Downloading the box software onto a memory stick and then powering up the receiver with memory stick in situ?

Cheers-Rotty Dave:cool:

[RottyDave]

Meant to say the vix software or the enigma 2 software?

[Creators]

This should help you ...
http://www.world-of-satellite.com/enigma2/openvix/openvix-builds/Guides%20and%20Tutorials/Flashing%20Guides/How%20to%20flash%20a%20Vu%2B%20Solo2.pdf

[RottyDave]

Thanks for that link-will read,refresh my memory and give it a go:thumbsup: