View Full Version : [VU+ Duo2] Fix: [TimerList] move Orb position after Service Name.
I already tried this fix and found it better than before.
But now the beginning of the channel name is cut off. :-(
I'd rather prefer the end to be cut off.
Skin: standard (VIX HD Night)
Thanks.
abu baniaz
22-05-14, 18:36
If you are able to, disable overscan on your TV.
If not, you will have to edit the OSD position setup
Menu > Setup > System > User Interface > Position setup
Reduce the width and move right/left. Reduce height and move down/up. You should just about see the ends of the box.
oh, thanks for the info. will try to adjust the osd accordingly.
now: i adjusted the osd but the beginning of the channel name in the timer list is still cut off.
did you turn off overscan on the TV ? 99.9% of these problems are caused by it
on my sony tv i can't turn off overscan.
on my sony tv its called 1x1 pixel or something
in the settings where 16:9 is etc, its in there
i know, but in this mode the tv picture doesn't completely fill the screen and an ugly border is left.
abu baniaz
22-05-14, 20:28
Upload a picture showing what you mean.
You are probably talking about pillarbox.
Oh boy, finally I was able to turn off overscan. The TV setting is called "Full Pixels" or something like that.
But: the beginning of the channel name in the timer list is still cut off.
34847
Channel name is:"Das Erste HD"
Oh boy, finally I was able to turn off overscan. The TV setting is called "Full Pixels" or something like that.
But: the beginning of the channel name in the timer list is still cut off.
34847
Channel name is:"Das Erste HD"
This is fixed in current test builds, so once Apollo is released, you'll have the fix.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.