PDA

View Full Version : [VU+ Duo2] back to previous channel button


bellejt
27-01-14, 17:41
Now in img we can switch back from channel trough the < > buttons.This however is with a list choice.Would it be possible to program the < button for the list and the > button to automaticaly switch to the previous channel (without going trough the list).
skippie
27-01-14, 18:07
yes this would be much appreciated if this would be possible again like it was in the past.
BubbleBalls
27-01-14, 18:17
Is that option not available already? It's in one of the menu trees?


Tapatālker
bellejt
27-01-14, 18:20
yes but not both functions at once.Or list or channel previous next.
BubbleBalls
27-01-14, 18:27
I'll have a look again when I'm home but I remember two or three options being added after Andy initially changed it - Unless it changed again since.


Tapatālker
bellejt
27-01-14, 18:37
thx for looking at it
BubbleBalls
27-01-14, 20:32
Menu. Setup. System. Button setup. Button setup. History buttons mode - change to just zap. Green button.


Tapatālker
Trial
27-01-14, 20:36
Hi,
disable panic button and use 0 for previous channel.

ciao
bellejt
05-02-14, 18:16
how do i disable panic button and were is it ? I am using dutch language om the VU.

@bubbleballs : that only gives one choice.What I would like is to have the left button < for entire menu and the right button > for switching to last called channel.So I can easely switch between 2 channels.
judge
05-02-14, 18:21
how do i disable panic button and were is it ? I am using dutch language om the VU.
Menu -> Setup -> System -> Channel selection settings -> Enable panic button



@bubbleballs : that only gives one choice.What I would like is to have the left button < for entire menu and the right button > for switching to last called channel.So I can easely switch between 2 channels.
Not currently possible.
bellejt
05-02-14, 18:28
oke thx.That did the trick.Will use 0 to switch back.Maybe the combination I am looking for will come on the future.
MrMister247
14-05-14, 19:30
Hi!

I have an ET6x00 and installed the latest OpenVIX-Image
Software
System OE: OE-Alliance 2.1
Distro: openvix
Firmware version: Helios.016
Driver date: 20130524
Kernel version: 3.8.7
Gui version: 2014-05-04

I tried to zap with 0 to the previous channel, but it does not work. I can not zap with < or > throuth the history. If I press 0 I see the first Channel (Number 1).

Do you have any idea?

Thank you for your support.

Greetings
MrMister
MrMister247
14-05-14, 19:36
OK, I just found the "Panic Button" - Setting - Disabled and it worked.

My mistake...

Best regards,
MrMister