vaudinsamways
17-01-14, 11:19
TM-Twin-OE
OpenVix 3.0
ViaAccess CAM v3.1
BIS Viewing Card Hotbird
After recently purchasing a TM-Twin-OE Satellite box, I have finally got it all setup successfully (thanks to the forum friends) apart from one problem! I cannot get the BIS Viewing card to decrypt the French tv channels on Hotbird as it did on my old TM7102HD box before it went kaput.
I have queried TotalSat who supplied the CAM & Card several years ago, as to whether the ViaAccess CAM needed changing to v5.1 which I now see on sale, but they said there was no reason why it shouldn’t work. The card viewing rights are updated on channels AB1 & Animeaux, and I have left it tuned to these for hours, without success.
I wonder whether there is either a software problem in the box or a fault in the CAM for the following reasons….
If I go in the menus to setup/softcam_CI/CI Assign/Module Retail…. the box crashes, gives a long error message which isn’t on screen for long enough to read ( but I think it says it is sent somewhere) and then the box reboots.
So, any ideas: as living in France we do like to watch the French tv sometimes, although nowhere as good as UK tv!
Do I need to change my CAM or hope for a software update?
OpenVix 3.0
ViaAccess CAM v3.1
BIS Viewing Card Hotbird
After recently purchasing a TM-Twin-OE Satellite box, I have finally got it all setup successfully (thanks to the forum friends) apart from one problem! I cannot get the BIS Viewing card to decrypt the French tv channels on Hotbird as it did on my old TM7102HD box before it went kaput.
I have queried TotalSat who supplied the CAM & Card several years ago, as to whether the ViaAccess CAM needed changing to v5.1 which I now see on sale, but they said there was no reason why it shouldn’t work. The card viewing rights are updated on channels AB1 & Animeaux, and I have left it tuned to these for hours, without success.
I wonder whether there is either a software problem in the box or a fault in the CAM for the following reasons….
If I go in the menus to setup/softcam_CI/CI Assign/Module Retail…. the box crashes, gives a long error message which isn’t on screen for long enough to read ( but I think it says it is sent somewhere) and then the box reboots.
So, any ideas: as living in France we do like to watch the French tv sometimes, although nowhere as good as UK tv!
Do I need to change my CAM or hope for a software update?