Gigablue QUAD RC TV BRAND CODE

[maviing]

Hi,

Could anyone give direction how to setup Gigablue Quad remote to control TV please (if it is posible)? Any instructions and tv brand codes?

Many Thanks,

[Tito_PTY]

Am looking for the same info.


Thanks!! :confused:

[Pieter H]

I have looked every where and asked the producer;no reply sofar!:mad::mad:
Am looking for the same info.


Thanks!! :confused:

[Joe_90]

Have you tried the support section/downloads on the Gigablue website? I'm not sure whether the policy on links extends to the manufacturer's website, but here is the link for the manual (manuel:)) for the remote for the quad plus in English and German:


http://www.gigablue.de/wp-content/uploads/2014/01/gigabluercu03manuel.pdf

[MrKappa]

I have the original RCU where, below the power button, on the second line, instead of Gigablue, TV, LCD the buttons are "F1, F2, F3, F4". I wonder if is possible to use them to control at least the tv.
I tried with a procedure found in the new manual but I had no success.

[Monkeynut1984]

Did anyone get to the bottom of this? I've had no joy so far!

[Monkeynut1984]

Scratch that - I found it!

Turn TV on, then press and hold TV button and OK button for 5 seconds, the keep pressing up button (above OK) till TV turns itself off. Press OK again and you're good to go

http://www.gigablue.de/wp-content/uploads/2014/04/HDQUADPLUSUniversalRemoteControllerManual.pdf

[MrKappa]

I did this procedure in the past but my RCU has only 4 buttons with F1,F2,F3 and F4 apparently not set yet for any action and this is not working for me.
But I sent a message to Impex-Sat to get support and I will keep you informed.