Channel Name in Graphical EPG

[baz135]

Since upgrading to Build 796 some the channel names only show n\a see attached photo
http://192.168.0.104/grab

Thanks in advance

[BubbleBalls]

This normally means the channels have changed transponder frequencies. Depending on how you manage your bouquets will mean either a manual or Automatic scan/ABM rescan/or update to your existing bouquets via another user set.


Tapatalker

[baz135]

Yes I thought that and therefore I did carried out a full re-tune and an epg update, but none of these actions resulted in fixing the problem. Thanks for your advice, have you any other suggestions?

[Trial]

Hi,
when a channel changed frequency then a re-tune/re-scan will not help to make n/a to disappear. After the scan you have to look for the channel and put them back into your bouquets and delete the n/a channel.

ciao

[Mr. Mister]

I just updated one of my Quads.. and exactly the same problem..
I only had about 20 channels showing the correct name,. All other channels all were named as n/a..
I did run ABM.. and that did not help.. Done a restart and still the same..
All the channels still work fine.. and when you select any channel marked n/a .. After a second or 2.. The proper name appears..

[Larry-G]

Try deleting the lame.db file in /etc/enigma2/ then run ABM again.

Sent from my GT-I9300 using Tapatalk

[Mr. Mister]

For me.. That fixed some of them but not all..

[baz135]

Try deleting the lame.db file in /etc/enigma2/ then run ABM again.

Sent from my GT-I9300 using Tapatalk

Thanks Pheonix, that seems to have fixed it for me.

[Rob van der Does]

Try deleting the lame.db file in /etc/enigma2/ then run ABM again.
But only do that if you only use ABM-channels.......!

It is not an uncommon phenomenon for N/A to show. This can also happen on installing any settings (from the feeds or via a settings editor). Best cure is to re-install the settings.