CCcam.cfg file not working with existing Sky Card

[600769307]

Hello,

I'm looking for some assistance getting my Sky Card working with with Vu+ Duo box. I've installed the latest Vix image and downloaded and installed Softcam. I have then created a the cccam.cfg file in the etc folder and inserted the following config:-

BOXKEY: /dev/sci1 serial Number in Hex
SMARTCARD CLOCK FREQUENCY: /dev/sci1 3570000

I've then restarted the box, but the subscription channels that I had before are still not working. Can anyone help?

[hilly]

try sci0 or try the other card slot if you have one.

[Stanman]

Are you getting any sub channels?

[600769307]

I've just tried sci0 but got subscription channels either. I can get Sky1, but no sports or Movies which I pay for through my subscription

[Stanman]

That points to a incorrect boxkey, how sure are you its correct?

The card is working as sub channels are clearing.

Are you getting non hd sports and movies?

[600769307]

I don't subscribe to HD, so I'm not getting those channels. I got the BOXKEY from the bottom of the skybox. I was told that you ignore the first six numbers and then remove the last one and then turned it into hex. Is this correct?

[Stanman]

Did you just input those numbers in? if so that is not the box key.

[600769307]

I turned into Hex first and then inputted it

[Stanman]

Using what? the calculator function?

I had a boxkeygenerator but cant find it now perhaps one of the other people with it can upload it but that's your best bet

[Stanman]

found it give it a go

[Burnham]

Once you could get the box key from a Telnet command. Stop CCcam , then Telnet CCcam -d - that starts CCcam and on the Telnet screen there should be a line like <boxkey>********</boxkey>

It is some time since I've had to use this, so I've not tested this recently.

On a general note your card should always be in the top slot - which is sci0 - I'm sure someone will post that in their box it doesn't matter which slot you use - but top slot definitely works with everything.