View Full Version : Epg freeze
DaMacFunkin
12-11-13, 13:56
Hi I'm having probs with epg freezing when reading titles, I've sort of just asked a question in the solo2 pages but as I understand it that box may or not have problems so I've moved to the nano thread which is defiantly having problems.
Thanks.
Do the following:
Telent init 4 commaned
FTP to EPG storage location and delete Crossepg folder and epg.dat
Telnet init 3 command.
Re-download EPG.
DaMacFunkin
12-11-13, 20:05
Doesnt work, crashes on reading titles 195kb again same as last night and the hard drive sounds like it can't read... do i not need to download an older version first?
If have exactly the same problem on my Duo. Reads to 195kb and then doesnt go any further. I only have partial EPG too.
Where are you guys saving EPG data to? USB, HDD, Network?
abu baniaz
13-11-13, 01:32
Just helped someone install Vix 783 afresh having been on 4D. Cross epg 0.7 downlaoded fine. He used a fat32 usb flash drive.
Mine is to a usb stick. The solution to this is to remove the crossepg plug in, reboot and re-install. Mine worked after that.
Never had a issue with the Nano or any other TM model with the new CrossEPG but after seeing this thread i flashed build 785 to test results below.
From start to finish it took just under 1 minute for sky uk and freesat.
Even after adding sky Ireland to ABM and doing a scan after it's done its work as well and it still only took just over 1 minute ( 1 minute 3 seconds to be exact ).
DaMacFunkin
13-11-13, 13:31
My epg saves to internal hard drive, I uninstalled the epg plug in, deleted files and installed the 6.8 version and it works fine, if you are saying I need to do a clean install with no restore to get 7 to work then that Is too much messing for me to do with 2 different boxes and a motorised sat setup on a work night.
My epg saves to internal hard drive, I uninstalled the epg plug in, deleted files and installed the 6.8 version and it works fine, if you are saying I need to do a clean install with no restore to get 7 to work then that Is too much messing for me to do with 2 different boxes and a motorised sat setup on a work night.
Still works perfectly for me using settings backups and clean installs, I have tested on all my Vu+ and TM-OE receivers with no noticeable issues, all of my EPG's are saved to either a internal HDD or a mounted USB stick, as for too much messing when you get round to it you should be able to do a full fresh install in less than 20 minutes i can do it in less than 10 on my boxes.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.