Update still running after 25 mins

[tomos]

Hi

I've just run an update on my Duo2 (34 updates in total) the screen currently says "Update in progress .... this should take a few minutes" it's been running for about 20 - 25 mins is this normal should I let it carry on or should I power the box off and on?

Tom.

[Sicilian]

Try this via telnet before powering off:


init 4 && opkg update && opkg upgrade && init 6

[Larry-G]

also what build were you on prior to initiating the update ?.

[tomos]

never used telnet before, do I type the instructions using telnet via a laptop?

[Sicilian]

Yes open a command prompt, but if you where trying to update a build older than 760 to latest you'll need to re-flash.

[tomos]

I've rebooted my box, it's restarted fine, but the 34 updates are still available to update, if I look at the changes via the " Software update" screen then "view the changes" the top line reads "openvix build 783"

[tomos]

I've open Microsoft Telnet typed in the line with the spaces comes back with "invalid command"
Will Telnet automatically connect to the Duo2 box or do I need to manually connect first?

[tomos]

30271

Hi Pheonix, I've attached a screenshot of my build

[tomos]

Yes open a command prompt, but if you where trying to update a build older than 760 to latest you'll need to re-flash.
Hi Sicilian, Ive managed to run that line via Telnet I think the updates are now applied, does that line of code always run the updates,

[Larry-G]

Hi Sicilian, Ive managed to run that line via Telnet I think the updates are now applied, does that line of code always run the updates,

yes thats the command to manually update the image i always use when updating multiple receivers ( i do one or two via the online method and the rest via telnet ).