softcam issue

[flickerrr]

Hi I have flashed new image and having problems getting mgcamd138 working. When i go into softcam its coming up at top - ACTIVE: ps: invalid option -- 'C', BUS;

Anyone any ideas?

Many thanks

[danivtec]

Have you tried 1.35 at openvix.co.uk site?

[Mr. Mister]

MGcamd i.38 does not work..

1.35a works perfectly and can get it from openvix.co.uk

[flickerrr]

Cheers guys how do i remove 138?

[Mr. Mister]

Long press Blue button
Then press red
Then go to cams
Highlight 1.38
and press OK

[flickerrr]

Ik thanks iv done all that and still getting same error coming up?

[danivtec]

Do you have the config file (mg_cfg) in the correct location?

[Mr. Mister]

both config files go in usr > keys

[flickerrr]

when you say both config files is that mg_cfg and newcamd.list? Thats all I have under usr/keys

[Mr. Mister]

Yep.. Thats all that should be in there..

Here are the 2 files you need.. Edit the newcamd.list file to your requirements..

[flickerrr]

Yeh thats what i have pal - funny thing is im getting channels (all of them) even though it says no softcam is running?

[flickerrr]

OK i have deleted the mgcamd altogether now and my channels are still clearing and i still have the invalid option showing under softcam setup? I dont have any softcam running what is going on?!

[afc_rich]

What happens if you hard reboot the box?

[flickerrr]

iv tried all that thanks - im doing another fresh flash now to see if it goes away. Find it strange im clearing channels with no apparent softcam running

[foz]

as this thread is softcam related:
if you run oscam the ecm info shows as cccam
foz

[mip185q]

Hi, Just to let you know that I have fixed my issue with the Venton HD box and mgcamd 1.35a and 1.38. It works fine with your files. Just a note to others, I did have to turn off CCcam extensions (settings from softcam manager) and just have oscam extensions set to Yes. Once you start the mgcamd 1.35a or 1.38 I found I had to wait a few minutes for the picture to be clear. The issue of the picture freezing on some of the channels seems to have gone away with mgcamd installed instead of cccam.

"Mr Mister" thank you so much, wouldn't have achieved it without your assistance and your two files.:)

[mip185q]

Thank you so much see post 16.