Cant select new sats to scan manually

[deckymckeown]

I am trying to maually adjust my system to add aditional sats. I have done this a few times already by:

1. Tuner configuration. Pick the satellite, deslecting usuals (as i dont have this set up), then selecting the store position for this sat.

2. I then go to manual scan, and add the frequencies for a transponder on that sat. Obiviously it wont find any channels as i havent moved the dish.

3. I then go to positioner setup to move the dish manually via remote. I usaly press red to go to tune and from this pick my new sat and enter the frequency etc.

Problem is now i cant select my new sat, only the ones that i have already configured

What am i doing wrong here, it worked perfectly this way earlier !!!

[bassethound]

After you have assigned your satellites a numbers you must do a full restart of the box and then the satellites will appear in the list

[deckymckeown]

Spot on bassethound, worked like a charm!!!

That was really annoying me how i done it before and couldnt quite do it again