Setup multiple lnb

[malaj]

I have today 4 lnb pointed to 0.8 w, 7e, 13e, 28.2e. I want also see 5e, which is close to 7e. Is that possible in Uno to setup so 1 lnb point to 5e and 7e? So i can with 4 lnb can see 5 sat.

[Rob van der Does]

Well, the setup won't be difficult at all (just assign the same LNB to both satellites).
But a separation of 2 degrees is certainly too much to ensure reception.

If you still want to pursue this: point the LNB to 6E.

[malaj]

Thanks Rob. I cant find out to setup my receiver. How should i setup?.

[Rob van der Does]

Menu --> System --> Service searching --> Tuner configuration --> advanced

[malaj]

Menu --> System --> Service searching --> Tuner configuration --> advanced

I have now tested but not working as I wan`t. My setup is as below. There is only signal from 0.8 w and from other LNBs. Do I miss something?

0.8w is allocated to LNB 1 and other parameter is default value
4.8e is allocated to LNB 2 and other parameter is default value
7.0e is allocated to LNB 2 and other parameter is default value
13e is allocated to LNB 3 and other parameter is default value
28.2 is allocated to LNB 4 and other parameter is default value

[Rob van der Does]

Well, I presume you are using a DiSEqC switch? So leaving other options as default won't work.

Look at the screenie for a possible setup. Of course the port should be different for each LNB.
AA = port 1
AB = 2
BA = 3
BB = 4

[malaj]

Well, I presume you are using a DiSEcQ switch? So leaving other options as default won't work.

It is correct, that I use DiSEcQ switch. Can you please advise me, because I have never setup it before

[Rob van der Does]

It is correct, that I use DiSEcQ switch. Can you please advise me, because I have never setup it before
I edited my post above.

[malaj]

Thanks I will try when I came from work today. Have a nice day

[malaj]

It works thanks.