thejoker
19-06-13, 22:33
Im on vix 3.0 683 on my vu solo. When running 2.4 everything ran smoothly, sometimes epg would not auto update but was used to that.
Ive did a full reflash of 683 and when I update epg, it dissapears after an hour or so, I think when box goes into standby or left for a while I loose everything. This was the case before when I lost power or turned off at the switch but this was normal, Im aware of that.
Box runs fine other than this but really dont want to be without my EPG...
Ive read others are having problems with picture freezing up and hard drive mounts disappearing, I have also noticed this along the builds of vix 3.0, on one particular build updating simply made the box go to a black screen which by googling I found out everyone elses did too..
Should I just go back to 2.4....as things ran alot smoother when I was on this image..
Ive did a full reflash of 683 and when I update epg, it dissapears after an hour or so, I think when box goes into standby or left for a while I loose everything. This was the case before when I lost power or turned off at the switch but this was normal, Im aware of that.
Box runs fine other than this but really dont want to be without my EPG...
Ive read others are having problems with picture freezing up and hard drive mounts disappearing, I have also noticed this along the builds of vix 3.0, on one particular build updating simply made the box go to a black screen which by googling I found out everyone elses did too..
Should I just go back to 2.4....as things ran alot smoother when I was on this image..