Latest Vu Solo 2 Image and Mgcamd problem

[327521609]

Hello Everyone,

I have just updated to the latest VIX image (openvix-3.0.678-vusolo2_usb) Its gone on fine. I have setup Mgcamd and added the config file / key off my old image and it clears but when I restart the box even though its enabled at startup the picture does not clear. I manually have to go into softcam manager and restart it, If I use CCcam and it works fine.

My sub guy told me I need to use Newcamd and not CCam but cannot find it as a IPK plugin anywhere to install to my box. Is Mgcamd the same as Newcamd?

Any help is appreciated (

[Mr. Mister]

Use this mg_cfg.. and post back ere to let us know all is ok..

[327521609]

Thank you I will try it now

[327521609]

Many Thanks its now working :-)

[Mr. Mister]

Glad you sorted buddy..

[buffalo0207]

I have the same problem with my Solo2 and BH image. I tried your config file above, but it still doesn't work - I have to manually restart Mgcamd after a reboot or restart of E2 otherwise I just get the black screen.

Can you help?