bushiee
18-04-13, 08:13
Hi Guys.
Having a bit of an issue after installing OpenViX 3.0.204 image on my et5x00.
Everything works fine until I install Mgcamd 1.35a. Then when I try and do a system reboot the box gets to the boot screen with the spinning vix logo in the top left and that's it.
The logo comes up about 8 times spinning half a dozen times each time then goes off completely and the screen just stays on the openvix screen.
I have tried with an older image and got the same thing, I have also tried without my hard drive attached and without the pen drive attached but its as soon as I install MGcamd 1.35a.
It was working OK before just getting a little slow so thought I would update.
Any help would be appreciated/advice
Cheers
Having a bit of an issue after installing OpenViX 3.0.204 image on my et5x00.
Everything works fine until I install Mgcamd 1.35a. Then when I try and do a system reboot the box gets to the boot screen with the spinning vix logo in the top left and that's it.
The logo comes up about 8 times spinning half a dozen times each time then goes off completely and the screen just stays on the openvix screen.
I have tried with an older image and got the same thing, I have also tried without my hard drive attached and without the pen drive attached but its as soon as I install MGcamd 1.35a.
It was working OK before just getting a little slow so thought I would update.
Any help would be appreciated/advice
Cheers