Flyingpig
03-03-13, 21:44
Hello All,
Earlier today I decided to do a backup of my ET9000 as it was working like a dream and I thought this is the setup I want to go back to if anything ever goes wrong.
Anyways, the gods are against me today, as during the backup I got an error message and the vix logo came up and never went off. After 10 minutes or so, I restarted the system by turning it off, however, it didnt even start to boot up.
I reflashed and installed Cccam and updated my config.cfg, then updated the channel list, restarted enigma and it got stuck in boot loop. I done it all again, then it went into boot loop, and then again.
At this point, I went hunting and found an old'ish backup, and used that to update once reflashed. I havent restarted the enigma to see if it gets stuck in boot loop as the wife and kids were getting restless.
any ideas what has caused that?
FP,
Earlier today I decided to do a backup of my ET9000 as it was working like a dream and I thought this is the setup I want to go back to if anything ever goes wrong.
Anyways, the gods are against me today, as during the backup I got an error message and the vix logo came up and never went off. After 10 minutes or so, I restarted the system by turning it off, however, it didnt even start to boot up.
I reflashed and installed Cccam and updated my config.cfg, then updated the channel list, restarted enigma and it got stuck in boot loop. I done it all again, then it went into boot loop, and then again.
At this point, I went hunting and found an old'ish backup, and used that to update once reflashed. I havent restarted the enigma to see if it gets stuck in boot loop as the wife and kids were getting restless.
any ideas what has caused that?
FP,